2 replies to this topic

[SmoKe42]

Hi everyone,

The back camera of my OSD stop working since last saturday. As many user I experienced the power button problem that I had solved with a small piece of foamboard. Though, it induces a deformation of the body.

I suspect this deformation allows the camera sensor to slightly move on the case and may affect the connector.

Fortunately, I managed to obtain warranty service for a new phone but I want to warm you about this.

[jikobutsu]

Deforms the case, how much u pushing under the button

A very small piece is all that is needed under the centre arm of button, it has no effect at all upon the casing, my case is exactly as it was before, a flush fit.

[SmoKe42]

jikobutsu, on 13 November 2012 - 04:11 PM, said:

Deforms the case, how much u pushing under the button

A very small piece is all that is needed under the centre arm of button, it has no effect at all upon the casing, my case is exactly as it was before, a flush fit.

I'm not talking about the case, but of the plastic part where you put the small piece to bring the power button up. This part also plays a role in holding the camera. The small piece inserted to repair the power button is only 0.5mm thick.