Few issues in setting up Froyo on my Blade, wouldn't be an issue if the fixes were included in step by step instructions. I upgraded from v4 Paul/ v5 Sabastian ROMs and everything appeared to be fine except Market and Google Voice complaining about login failure. Later discovered that agps was not included and screen resolution was too high causing phone keypad to be a microscropic as well as some other apps.
The key to fix the Market and GVoice was easy one by following the link below that states correct order of install. Since I had already updated with ROM, I did a factory reset from privacy menu and followed on from step 7.http://wiki.modaco.c...p/ZTE_Blade_2.2
Few people suggesting few things about LCD Density but the patches listed on thread below work if you know how to implement them. Some apps that change LCD Density require rooting the device and rooting using Universal method is better and easier but the change to density is temporary until you reboot so go with the permanent fixes using the patches provided by superkryo.http://android.modac...build/page/300/
In order to do this you will have to have ADB SDL installed and working, if you know little bit of linux you can test by "adb shell" and then commands such as "ls" etc.
However you cannot simply push files since it will be mounted as readonly so before you start you will have to enter "adb remount" and then follow with commands although there is a typo in step 1 where gpsconf should read "gps.conf".
After these fixes I am happy with the Froyo ROM on my Blade and hope this helps everyone else on the forum.