I have been using the Vegacomb 3.2 build 9 with the ver 3 update for a while, I decided to install HoneyIce 3.2.7 and proceeded to do the usual,
Boot into recovery
Select install from Zip and allow it to do its thing
Select re-boot from the recovery menu
That is where everything went wrong, now I only get the backlight when I power on
When I try the Back/Power/Back button combination to get into recovery it just doesn't work, the backlight comes on even after 1 second into the recovery attempt.
Both my XP and Vista computers do not acknowledge the vega when plugged in so what I have is
I can't get into recovery on the Vega and it does not boot only the backlight.
I cant use Vegatools or Audi as none of my computers recognise that the vega has been plugged in.
I desparately need help to get the Vega up and running again
Thanks in anticipation to anyone who can help
I searched the forum and found a reference to holding the power button for up to a minute so I tried the back/power/back buttons routine but kept the back and power buttons pressed after the backlight came on, after about 35 seconds the backlight went off, I then connected the vega to my pc and it was recognised, after that it was a case of install modded stock rom with VegaTools and then reinstall the veacomb 3.2 build 9 and update 3 as normal.
Still not sure whether to try the HoneyIce 3.2.7 again
Spoke too soon, used the Vega for a couple of hours in the evening including adding a few apps from the market and moving some apps to the SD using Apps2SD, then powered down suing the menu option from the power buton, this afternoon when I switched on... backligfht only.
Tried the back/power/back combo with no luck and also holding the power button as I did previously, still no luck.
I'll keep trying and post what I do and the results in case it helps anyone else
Edited by Egroeg, 19 December 2011 - 01:29 PM.