sparhawk76, on 25 December 2012 - 10:04 AM, said:
dr.pythagora: I was working on a build for our phones when I lost the harddrive containing my build environment. Something in the phone is slightly different than the European version and the stock CM9 build will not work on our phone (I've traced it down to an incompatibility in the RIL Layer). Hopefully after the crazyness of the holidays settles I will have time to rebuild my build environment and will try and get a build out that works on the e400r.
To flash back the stock firmware on an e400r download it from the site mentioned above, then flash it by using KDZ_FW_UPD.exe after booting the phone into emergency mode by booting with both volume buttons held.
Sometimes after reflashing the firmware you will get stuck in a boot-loop, if you do, unplug the phone and remove the battery. Hold both Volume Down, and the center button down, then turn the phone on while holding them. This will reset the phone back to all stock settings.
thanks for your message.
I did flash the V11 file linked above. All seemed to work fine, and the process completed with a "FINISH" word.
To mention that in the list of log messages I did have a fail message (something about 'set ....' at the begining of the flashing process).
After flashing the V11 file, the phone boots normally and nothing is different from my previous rom - all the apps there, the same pb with the network. It seems that V11 flash did nothing.
However, when I hard reset with "Vol up + Down + Power", then the phone really goes to stock firmware, but still no network.
Does V11 flash the radio as well?
Is there any way how to check whether my radio/modem fails physically?
Edited by dr.pythagora, 26 December 2012 - 11:36 AM.