Whatever you do - you do at your own risk)
! Each item was written for a reason, and you can not miss anything! Before starting to sew, read and see everything clear for you! If you have any questions before you ask, look for answers to the following 5 pages! If the problem with the actions of the driver on the PC, see! If you are not sure of themselves, do not risk!
1.Zaryazhaem phone more than 50%, remove the rear cover to the whole process (which would not 5 times removed).
2. makes backup NV (only the fourth item on the link) , Thanks just-max
3.Raspakovyvaem dump 2.3.6 and DFU Tools in a separate folder. Enter the phone in DFU-mode - the battery, hold down the "+" and "-" stick a USB, press the Power button while still holding + - phone must see how ZTE Handset Diagnostic Interface (DFU) (COMx). (If seen as an unknown device - put wood from native package ZTE .
4.Zapuskaem DFU Tools, on the right side indicate the path to the dump 2.3.6, the left selects all jackdaws. Galka on the right is selected. clicks the left button at the bottom and look forward to completion. Upon successful completion of the phone will go into FTM-mode.
5.Zakryvaem DFU Tools, reboot the phone, loaded the Chinese firmware. settings menu you can change the interface language to English (gray letter A).
6.Kachaem and throws the stick board of the Russian 2.3.6 ( thanks serviser ).
7.Vklyuchaem yusb debugging on, connect to your PC, download the cwm , open and run the recovery 22.214.171.124.exe, press enter until the window closes. switch off the phone, turn and hold Alt + it comes back to the Chinese rekaveri:
a) in hieroglyphs select menu item 5,
in the menu we see four options - so here are the first two is the choice of the firmware file, and the last two have to play, because you need to disable signature verification firmware and script approval. - Press - look what came out character (this is probably the Chinese yes or no), open the menu below - and sought to have had the same character. Next, using the first two rows, select the firmware file (from step 6) and sew. We wait progressbar is full and the appearance of three characters. Reboot of cwm or twitching batteries. (If the flash does not work, then the last two menus to put in the opposite meaning)
8.Kachaem ics Russian , update.zip - to root. In the settings, select "Update" and sewed up 4.0.4
9.S QPST help restore previously removed backup radio module tab Restore (checkbox is not selected.)
Written Materials gavrila and [HC] HUNTER . Many thanks. Posted 04.10.2012, 20:25: To calibrate the proximity sensor * 983 * 0 # menu sensors. If the instability began working display calibration - * 983 * 29873283 #.'s an easy way to root 4ke After the first boot of the system, be sure to do the following: 1) Send the device to reboot, and after he will once again be included - pull the battery for half a minute . Then I put the battery back in and turn on the phone. If this does not make the phone, perhaps instead of turning off to reboot. 2) go to the menu - Recovery and Reset - Reset and reset in the menu settings to the factory. If not, the phone can become unstable View Post myshar - 11.02.2013, 21:55