Jump to content

Recommended Posts

Guest roozbeh
Posted

i have an imate smartphone .. i connect my phone without battery to power and later i cannot turn it on . what can i do ??? help plz !!!

Guest awarner [MVP]
Posted

Do you mean after you have reconnected your battery the phone will not turn on?

Guest roozbeh
Posted

well....my is down....here is what happened:

i saw it powered off and then i turn it on...later i saw again it is off and then afterwards it doesnt start......

and when i connect it to charger the yellow led doesnt show.......

also when i remove batry and then connect charger the led become red for very very short time and then again nothing happens....

the only thing i can think of is that charger is dead or.........(i checked output of charger with voltmetr it was 5.5v and 1.1amper....i think it means charger is ok...)

does phone starts without batry and with use of charger only?

heeeeelp plz

Guest siu99spj
Posted

Err, not entirely clear on what you are asking, but I know for certain you can turn on the ORIGINAL SPV on without a battery, but you MUST have the charger connected.

The red LED is USUALLY shown when your battery charge is extremely low and you have just connected the charger. If its flashing red, then your charge is very low and you should recharge the phone.

Yellow (Non-flashing) means the phone is charging, green (non-flashing) means the phone is charged, flashing yellow is when the phone is low on charge (not being charged) and flashing green is when the phone has plenty of charge (Not being charged).

Even when the phone is off and you connect the charger, the batery should show yellow and green.

You also cannot turn on the phone when the red LED is shown, only when it is yellow or green.

I hope this is a bit clearer!

Guest roozbeh
Posted

yeah thanks.......

but my phone i think got some kind of disease!!!!

it goes off and then i cannot turn it on with charger and no batry also....but after some time it starts....and whenever it goes down the batry immediatly finishes.....

i think it has some kind of hardware problem......

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.