Guest rion Posted April 24, 2004 Report Posted April 24, 2004 guys, marami nang problema ang SAP ko, gusto ko sana i hard reset, paano ko ba gagawin yun? I already followed this instructions, peru hangang step 6 lang ako kasi wala na akong options pagkatapos sa step 6: 1) Remove the battery and wait 5 seconds. Replace the battery 2) Press and Hold voice recorder button (below power button on the left) 3) Power-on the device 4) The device will enter a special power-up mode 5) "Card found" will be displayed on the screen 6) Shortly after you will receive two options: "Press any key to enter boot loader" "Press action button to enter diag mod" 7) Press and hold the Action button 8) After a few seconds a menu will be displayed 9) Select "Erase IPSM" and wait for the screen to display "PASSED" 10) Then move to the left with the navigation button and select "END" 11) A screen with three colors will be displayed You may now remove and replace the battery and perform a normal power up. :D (Note: This may take several minutes)
Guest BrAGoL Posted April 24, 2004 Report Posted April 24, 2004 timing lang kailangan pag nag-prompt na yun... press the action key for about 2 seconds... Posted from my SmartPhone!
Guest Stryper Aquila Posted April 24, 2004 Report Posted April 24, 2004 @rion, bragol is right, you have to be patience on doing the step 6, TIMING baga. I also suggest that you download for a SPRITE BACK UP apps for you not to be hazzled of installing apps :wink:
Guest kalinte Posted April 24, 2004 Report Posted April 24, 2004 after powering on just click and hold fro two sec the joystick. that should do it.
Guest rbginandoy Posted April 26, 2004 Report Posted April 26, 2004 @rion, They are right pre, gud timing lang. I have tried it (ung nasa step 6) maybe for almost 30 times before managing sucessful ung hard reset ko. :D
Guest rion Posted April 26, 2004 Report Posted April 26, 2004 wala talagang nagyari, I've hold on for 5 secs, hangang Canary MV v.109 lang ang display..
Guest gpcarreon (MVP) Posted April 26, 2004 Report Posted April 26, 2004 Record button then Power On...magloload ng white then may makikita ka nakasulat sa upper left corner ng screen saka mo pindutin Action button...then pag successful, may mga numbers 1 to 8. Number 8 yung Erase IPSM or hard reset button. :D
Guest vince06 Posted April 26, 2004 Report Posted April 26, 2004 ganyan rin nangyari sakin. if you have the plastic "memory" card which came with the SAP inserted in the slot where SD/MMC cards go, take it out, do a hard reset without anything inserted in the slot, and you should get past #6. worked fine for me. goodluck!
Guest BrAGoL Posted April 26, 2004 Report Posted April 26, 2004 yep! tama si vince06... kung nakakabit pa nga yung dummy card sa sd/mmc slot, tanggalin mo muna then proceed agen... Posted from my SmartPhone!
Recommended Posts