It's very hard to get my SD card out of my mpx200

[Guest aRuCaRd_esp]

Well first of all, hi! I'm new to these forums and i'm currently searching some help because yesterday i have bought a SD card of 1gb but if i put it in my mobile if i want to get it out of it its really hard normally if you push the sdcard a little bit it jumps out.. Well in my case that don't happen it just raise 1mm up and it's really difficult to get the card out of the mobile phone.. Somebody had the same problem? what should i do and what can i do?

Thanx and greets,

[Guest awarner [MVP]]

Presumably the new card is much thicker than your other cards?

If so it could be down to the design and there may not me much you can do.

[Guest aRuCaRd_esp]

Presumably the new card is much thicker than your other cards?

If so it could be down to the design and there may not me much you can do.

<{POST_SNAPBACK}>

Hi, thanx for you reply,

The card is TakeMS and i tried to put it in a friends mpx200 and it goes well.. I don't know why mine mpx isnt working fine cause it's new (2weeks old) and yesterday it was the first time i introduced the sdcard in it, maybe if i open the mobile i can repair it?? Anyone knows it?

[Guest awarner [MVP]]

If it works in your friends MPX200 then it may be that his latch mechanism is slightly more worn than your new phone.

[Guest aRuCaRd_esp]

Well his phone is newer then mine, anyways i also thought about it, that the mecanism should get used to it, but i put the card a lot of times inside and outside and there was'nt any improvement, i can strangly believe it. Anyway i don't care that much cause i don't get the card much times out of it, but it's quiet strange...