spv e200 wont pick up gps even though it is paired

[Guest taz2023]

;) :D

hi can anyone help me on this...

i have a spv e200 phone and a gps reciver with a NEMERIX GPS Module.

the problem is that after bonding devise's together and i try to run tomtom when i am plotting a route it says waiting for a valied gps signal..

i have driven round trying to pick up signal but it don't pick one up..

Moor info on the gps .........

Specifications

General

Accuracy

GPS Chip NEMERIX GPS Module

Position

Frequency

L1, 1575.42MHz

3meters CEP (50%), without SA (Horizontal) 7 meters (90%)

C/A Code

1.023MHz chip rate

Velocity 0.1 m/sec. without SA

Channels

16 CH all in view tracking

Time

±100 ns synchronized to GPS time

Antenna (Intemal)

Built-in low noise

Datum

Extemal Antenna Port Active MMCX Antenna

WGS-84 (or by demanded)

Sensitivity

Dynamic Conditions

To – 152 dBm Tracking, Superior Urban Canyon Performance

Altitude

<10,000m

Acquisition Rate

Velocity

Hor.300km/hour ; Ver.36km/hour Max

Cold Start

60 sec, average

Acceleration

2g Max

Warm Start

38 sec, average

Motional Jerk

4 m/sec3.

Hot Start

12 sec, average

Interface

Reacquisition

1 sec, average

Communication Protocol

Accuracy

Communicate with host platform via

Position

5m CEP (50%), 9m (90%)

Bluethooth (2) serial port profile

Velocity

0.1m/sec, without SA

Bluethooth communication distance 10 M. TYP.

Time

±100ns synchronized to GPS time

GPS Protocol

Power

Default: NMEA-0183 (V3.01) – GGA, GSA, GSV, RMC,

Built-in rechargeable 850mAh Li-ion battery and 5 V DC input

the update interval 1 second (Default)

Operation Current

45mA (Typical)

Band rate 9600 bps (Data bit : 8, stop bit : 1)

Operation Time

18hrs, after fully charged, in continuous

Device Size

Charging time 2.5hrs. (Typical)

81 (L) X 44 (W) X 20 (H) mm

Environmental

3.2 (L) X 1.75 (W) X 0.79 (H) inch

Operating Temperature

- 20 ℃ to + 60 ℃

Accessories

Car charger (12V in, 5V output)

Relative Humidity

5% to 90% non-condensing

Hope some one can help.. thanks

Edited April 24, 2005 by taz2023

[Guest read2912]

;)  ;)

hi can anyone help me on this...

i have a spv e200 phone and a gps reciver with a NEMERIX GPS Module.

the problem is that after bonding devise's together and i try to run tomtom when i am plotting a route it says waiting for a valied gps signal..

i have driven round trying to pick up signal but it don't pick one up..

Moor info on the gps .........

Specifications

General

Accuracy

GPS Chip NEMERIX GPS Module

Position

Frequency

L1, 1575.42MHz

3meters CEP (50%), without SA (Horizontal) 7 meters (90%)

C/A Code

1.023MHz chip rate

Velocity 0.1 m/sec. without SA

Channels

16 CH all in view tracking

Time

±100 ns synchronized to GPS time

Antenna (Intemal)

Built-in low noise

Datum

Extemal Antenna Port Active MMCX Antenna

WGS-84 (or by demanded)

Sensitivity

Dynamic Conditions

To – 152 dBm Tracking, Superior Urban Canyon Performance

Altitude

<10,000m

Acquisition Rate

Velocity

Hor.300km/hour ; Ver.36km/hour Max

Cold Start

60 sec, average

Acceleration

2g Max

Warm Start

38 sec, average

Motional Jerk

4 m/sec3.

Hot Start

12 sec, average

Interface

Reacquisition

1 sec, average

Communication Protocol

Accuracy

 

Communicate with host platform via

Position

5m CEP (50%), 9m (90%)

Bluethooth (2) serial port profile

Velocity

0.1m/sec, without SA

Bluethooth communication distance 10 M. TYP.

Time

±100ns synchronized to GPS time

GPS Protocol

Power

Default: NMEA-0183 (V3.01) – GGA, GSA, GSV, RMC,

Built-in rechargeable 850mAh Li-ion battery and 5 V DC input

the update interval 1 second (Default)

Operation Current

45mA (Typical)

Band rate 9600 bps (Data bit : 8, stop bit : 1)

Operation Time

18hrs, after fully charged, in continuous

Device Size

Charging time 2.5hrs. (Typical)

81 (L) X 44 (W) X 20 (H) mm

Environmental

3.2 (L) X 1.75 (W) X 0.79 (H) inch

Operating Temperature

- 20 ℃ to + 60 ℃

Accessories

Car charger (12V in, 5V output)

Relative Humidity

5% to 90% non-condensing

Hope some one can help.. thanks

<{POST_SNAPBACK}>

hi, dont get your hopes up , i havent an answer to problem infact i have the same problem myself and am seeking advice also. i have just got a leadtek gps 9537 which ive paired with spv c500 and have exactly same prob as you, if you get any answers before me let me know

cheers