Calling card numbers and pins

[Guest Dark Horse]

Is there anyway of storing account numbers and pins for calling cards in WM2003 contacts so that you don't have to enter either of them?

Typically, on Nokia's and Siemen's moby's you just add a # or a * so the number is stored as for example:

080012345#11223344#1234

In this case, the calling card number is 080012345, the account number is 11223344 and the pin is 1234 meaning you can just dial the number and get through straightaway without having to enter either the account number or pin.

I've tried both # and * on WM2003 and it doesn't get any further than just dialing the telephone number and then prompting me to enter an account number.

Regards,

Dark Horse

[Guest devalmehta]

While entering the phone number look for the "Hard Pause" option. It will let you insert a pause between the numbers:

Callingcardno PAUSE accno PAUSE pin

Cheeers!

[Guest roma0803]

Yes, these options enter a "p" (pause) or "w" (wait) in the phonenumber. But with me it doesn't work and just the digits until the pause are dialed, then it stops. Might be a network issue...

[Guest elziado]

Yes, these options enter a "p" (pause) or "w" (wait) in the phonenumber. But with me it doesn't work and just the digits until the pause are dialed, then it stops. Might be a network issue...

<{POST_SNAPBACK}>

I am using WM5 and for some reason the p works but not the w (unless the wait is bloody ages and I didn't wait long enough!)

By the way has anyone found a "send DTMF" option? I used to do it that way.

Edited February 9, 2006 by elziado