How to switch contact select options in new Qtek firmware?

[Guest dleasman]

In my original Tmo SDA firmware, when you selected a contact, it would pull up all the contact info, or when you selected a number that you previously dialed, it would pull up the call time, duration, etc...

The behavior was the same after I upgraded to the iMate firmware.

With the new Qtek firmware, the behavior is different, and I don't like it... When you select a previously dialed number, or contact, it automatically dials. To pull up any info, you must press the Menu key and then select Open.

Where is the switch that controls which way it will behaive?

I hope the above explanation makes sense... If not, I can try to clarify.

-Dana