Problem of tomtom going to standby

[Guest mistercash]

Have done an upgrade of the rom (RUU_Prodigy_2180706_21807106_20710_QTEK_Generic_DUT_Ship_2)

Now when I'm using tomtom to navigate after a minute it goes into standby mode so that I can't see the route.

Then I have to tab the touchscreen and give my pincode.

I had this also set up in my older version and didn't had this problem at all.

It seemed then that he knew that when an app in full screen was running he didn't wend in standby.

Now he goes in standby.

Can somebody help me?

Maybe it is a reg key that need adaption or so.

Found the fix on this board thx:

I have a fix! (I think)

1. Get a registry editor (I used minied of sourecforge.net, because its opensource, but there are many others available)

2. Go to the following key:

HKEY_LOCAL_MACHINE\Comm\Security\LASSD\AE\{50C13377-C66D-400C-889E-C316FC4AB374}

- The value called AEFrequencyType will be 1. Change it to 2.

- Ensure the value called AEFrequencyValue is 0

Exit the editor and reset the device.

From now the device should only lock to the password screen when the power shuts off, as per pre-AUK2 behaviour.

Note that if you go in to the lock settings screen, it will try to change the AEFrequencyType value back to 1. Also, this will *not* work if you have an Exchange 2003 enforced policy for this setting active. The policy will overwrite it.

Edited October 9, 2006 by mistercash