Removing Mother Board (QTEK 8310)

[Guest jrdas]

Can someone show me how to remove the mother board from a qtek 8310 because i new to replace my keypad and i dont want to snap anything... please some help possibly a picture guide... THANKS!

[Guest greenturtle]

Hello jrdas, there are two guides on the forum in the Tornado section. Are these of any use?

http://www.modaco.com/C600-Faraday-diss-assem-t240271.html

http://www.modaco.com/Mate-SP5-Tornado-Disas-t241033.html

[Guest jrdas]

ive removed everything but i just dont no how to remove the mother board, i dont see no clip or anything?? helpppppp

[Guest mikeeey]

ive removed everything but i just dont no how to remove the mother board, i dont see no clip or anything?? helpppppp

usually there's 2 pieces of plastic (from the case) on the left and right side that is holding onto the motherboard. you must pry these apart (i kno i make sound like you will break it lol, be careful when you do that), and the motherboard should fall into your hand. also make sure you have unplugged the 2 flat wires attaching to the camera, and the keypad.

still dont see anything? well tell me, what can u see that keeping this motherboard attached to the device and keeping it from falling out?

Edited July 28, 2007 by mikeeey