Change ringtone/vibrate/LED flash characteristics

[Guest]

Taken Word for Word from, "Jane Lee" on http://www.pocketpcaddict.com... HUGE HELP TO ME WHEN I WANTED TO CHANGE STUFF..

Change ringtone/vibrate/LED flash characteristics

If you would like more control over how your device rings/vibrates/flashes its LEDs on events, you can can change the Script values of these events. For example, for an incoming call performing 'activate device, play ringtone, wait 3 seconds, repeat':

HKCU\ControlPanel\Sounds\RingTone0\Script = "apw3r" (REG_SZ string, no quotes)

For performing 'active device, set volume to 33%, play ringtone, set volume to 67%, play ringtone, set volume to 100%, play ringtone (no repeat)':

HKCU\ControlPanel\Sounds\RingTone0\Script = "ac33pc67pc100p" (REG_SZ string, no quotes)

The following are the full codes available to you. Please note that all the codes are executed simultaneously except after a ringtone play / wait code. E.g. 'v1p' will vibrate and play at the same time, while vibrating for 1 second. But 'pv1' will play the ringtone through all the way first, then start vibrating for 1 second.

a = activate device

cN = set volume to N in percentage max volume

fN = flash notification LED for N seconds

p = play ringtone. Note that this will play the ringtone all the way through before continuing with the next code.

r = repeat. Note that this should be the last code in your Script string, if used at all.

vN = vibrate for N seconds

wN = wait for N seconds. Note that the device will wait this long before continuing with the next code.

http://www.pocketpcaddict.com/forums/windo...cteristics.html