Updating to DXHI2

[Guest danarc]

Can anyone please provide with with the step by step process of upodating my omnia through vista and xp thanks. Thanks ;)

[Guest L.P]

Can anyone please provide with with the step by step process of upodating my omnia through vista and xp thanks. Thanks ;)

Try this:-

http://www.modaco.com/content/i900-omnia-h...hings-go-wrong/

[Guest danarc]

any help?

[Guest danarc]

Try this:-

http://www.modaco.com/content/i900-omnia-h...hings-go-wrong/

If am correct, i dont think its the same because its different firmwares

[Guest L.P]

If am correct, i dont think its the same because its different firmwares

From http://www.modaco.com/content-page/272065/...ppened/page/20/

1. Installed Active Sync 4.5 (restart XP).

2. Installed XP Samsung Modem Driver (restart XP).

3. Connect phone with USB Cable & switch phone on.

4. Wait for Active Sync to say Connected.

5. Run [i900 Dependant on what your installing.exe] Updater.

6. Switch off phone & wait for the screen to turn off completely (note pressing the reset button is no good).

7. Switch on phone.

8. Update software should then detect phone.

9. Click the start button on the update software.

10. EBOOT, PDA, CSC, updates will process each in turn, then the USB port will disconect.

11. Com port will be found (if not refer to below note).

12. Phone, plus a few other updates will then be installed, updater will say 'Job Done' and the phone will reset.

13. Phone will take a few minutes to boot, then will auto reset for preconfig settings.

If Com port fails at step (11) then do:

At this point the updater will have failed to find a com port and the update now says failed, your Omnia will have hung on the boot screen with a full green bar at the bottom, but dont panic!

This is because a new driver being installed to XP during this process dident install in time during the com port search, so just wait for the driver message to pop up in XP saying something like 'Hardware is now ready to use' give it a 10 second wait, then close the failed updater application.

Now re-run the updater application, and then press reset on your Omnia, the updater should again find your device, and you should now repeat from step (9), this time it should install all the way!

However if this dosent work don't blaim me i'm just detailing my experience.

Although its regarding flashing branded handsets, The procedure reamains the same.

BE WARNED YOU FLASH YOUR PHONE AT YOUR OWN RISK

[Guest danarc]

From http://www.modaco.com/content-page/272065/...ppened/page/20/

Although its regarding flashing branded handsets, The procedure reamains the same.

BE WARNED YOU FLASH YOUR PHONE AT YOUR OWN RISK

thanks