Change the sound of OMNIA not first soft then louder

[Guest ketamdaco]

Dear Paul or the others

is it possible to change the kind of sound of Omnia ringtone that first soft the getting louder. i really dont like it, cuz sometime when we have miscall we cant notice it.

thanks

[Guest sonic76]

Dear Paul or the others

is it possible to change the kind of sound of Omnia ringtone that first soft the getting louder. i really dont like it, cuz sometime when we have miscall we cant notice it.

thanks

Hi ketamdaco,

it is posible! "but" all Samsungmobiles use this ringtones and we need

a firmwrepatch to slove this ugly ringtonevolume!

there are a lot patches for other (non WinMobile) phones around the internet

and i hope somebody make a patch 4 the Omni!

For me such tone makes no sense!

regards

Sonic

[Guest ketamdaco]

Hi ketamdaco,

it is posible! "but" all Samsungmobiles use this ringtones and we need

a firmwrepatch to slove this ugly ringtonevolume!

there are a lot patches for other (non WinMobile) phones around the internet

and i hope somebody make a patch 4 the Omni!

For me such tone makes no sense!

regards

Sonic

Thanks Sonic for your comments

So there is still hope that i can solve this ugly ringtonevolume of omnia ;)

Plz somebody, help.....

[Guest Shadowy]

Found this on PPCSG, I haven't tried it so I've no idea if it works:

Change ringtone/vibrate/LED flash characteristics

If you would like more control over how your device rings/vibrates/flashes its LEDs on events, you can can change the Script values of these events. For example, for an incoming call performing 'activate device, play ringtone, wait 3 seconds, repeat':

HKCU\ControlPanel\Sounds\RingTone0\Script = "apw3r"

For performing 'active device, set volume to 33%, play ringtone, set volume to 67%, play ringtone, set volume to 100%, play ringtone (no repeat)'

HKCU\ControlPanel\Sounds\RingTone0\Script = "ac33pc67pc100p"

The following are the full codes available to you. Please note that all the codes are executed simultaneously except after a ringtone play / wait code. E.g. 'v1p' will vibrate and play at the same time, while vibrating for 1 second. But 'pv1' will play the ringtone through all the way first, then start vibrating for 1 second.

a = activate device

cN = set volume to N in percentage max volume

fN = flash notification LED for N seconds

p = play ringtone. Note that this will play the ringtone all the way through before continuing with the next code.

r = repeat. Note that this should be the last code in your Script string, if used at all.

vN = vibrate for N seconds

wN = wait for N seconds. Note that the device will wait this long before continuing with the next code.

[Guest bobobird]

Thanks Shadowy - makes no difference, still starts off low then high. Even tried setting first c to 100 and reset. Made no difference. Perhaps others will have better luck...

[Guest ketamdaco]

ya, its not work yet, have any other idea?

[Guest Thugbear76]

I hope someone has - it is the one thing that bugs me... If I dont wanna be emberrased (like some say is the reason Samsung did this) i will set it on the proper soft then louder setting. Gimme back the *i got scared pantiesless* that i had with my old nokia... ;)