Ringer sound goes off after only one 'ring'?

[Guest Flash_Gordon]

No matter what ringtone I use - on receiving a call - it plays it once and then the ringtone stops working and only the vibration carries on for each call.

I am using HI1 f/w.

Anybody else get this?

Cheers

FG

[Guest mkc_vx]

Go to Sounds by clicking:

Start -> Settings -> Phone -> Sounds -> Ring Type

From there scroll down and choose the type that suits you.

Regards.

Edited October 18, 2008 by mkc_vx

[Guest Flash_Gordon]

Go to Sounds by clicking:

Start -> Settings -> Phone -> Sounds -> Ring Type

From there scroll down and choose the type that suits you.

Regards.

Hi, I had done all that....but no matter which ringtone (custom of Samsung) or ring setting I use (with or without vibration) the ringtone cuts off after a couple of seconds....then returns just as it is about to go to voicemail...so about 10 secs after it cut out.

It has happened using diff firmware also.

Any ideas?

Cheers

FG

[Guest Flash_Gordon]

No matter what ringtone I use - on receiving a call - it plays it once and then the ringtone stops working and only the vibration carries on for each call.

OK...after much testing and stuffing about...I found the cause of this cut-out was MS Voice Command.

Checking out someone else's difficulties of another matter put me on to this.

The version I was using was 1.6.19209...

On removing this and installing the latest version available of 1.6.19214 - it seems now to be OK...

I now get the initial 2 second "quiet" ring then onto much louder normal ring...so far so good.

Now if only I could get the 'Lock/Unlock/Close' issue resolved...but that's another (thread) story. :lol:

Cheers

FG