[FIXED]Acer download tool said "not connected" while updating to froyo, bricked Liquid E?

[Guest pieceofplastic]

I figured it out, I had to plug it in and put the battery in and hold the power button once the battery showed up on the screen, then it was recognized by my computer and I installed malez recovery .6 and then booted to recovery from adb and installed my lcr zip that I left on my microSD.

:lol: I'm so relieved my phone isn't broken

I think i'll just wait for the official froyo release from acer :)

Edited September 25, 2010 by pieceofplastic

[Guest B4rt]

remove the battery, wait for 5-10 mins.

Try again. It does work sometimes.

[Guest Andy__P]

I had that a couple of times. If it says AMSS start and not connected you can unplug and replug the usb and it will continue.

[Guest pieceofplastic]

well i tried booting into recovery after unplugging+taking out the battery and putting the battery back in and this is what it says:

Partition checksum

 splash1:chksum =00000000 OK

 boot:chksum =00000000 OK

 recovery:chksum=1770c035 !=002152e0 **fail**

 system:chksum =00000000 OK

=======

<<FAIL>>[/codebox]

I don't know what I should do now. :/

Edited September 24, 2010 by pieceofplastic

[Guest Temur]

if there is "not connect" after 10 seconds you have usb cable out and plug in again. And if it is standard in recovery mode, I think you have to press the "home" button.

Sry for my super google-translate english^^

[Guest Mr.Big]

I had the same problem, tried everything like combo buttons, flashing from blah blah... everything was unsuccessful, it stopped after the AMSS was flashed until I remove the acer tool and acer drivers completely and re-install them all again. And now my liquid is running Foyo, oh yeah!!!

Edited September 24, 2010 by Mr.Big