Dust removal of SF [OLED]

[Guest theoscat]

i followed this thread

http://android.modaco.com/content/zte-blad...s/#entry1592905

after i disassemble and pump the dust off the oled panel,

i ressembled it and turned out the display is irresponsive,

and the physical buttons are fine,

is there any way to perform a self check by mself?

thanks

Edited April 14, 2011 by theoscat

[Guest Mushroom_Lord]

Is the ribbon cable Ok?

[Guest theoscat]

Is the ribbon cable Ok?

as far as i see,

the cable are still intact...

so i have no idea why the display is not responding :)

[Guest theoscat]

is there any precaution when ressembling the device :)?

why am i the unlucky one :)

[Guest theoscat]

when i trigger the menu or power off,

the first option are always highlighted (like i m pressing on it)

any ideas.....:)?

[Guest ThrashMan]

When you were removing the dust, did you seperate the touch screen from the motherboard?

If so recheck the connection on the ribbon cable.

[Guest theoscat]

When you were removing the dust, did you seperate the touch screen from the motherboard?

If so recheck the connection on the ribbon cable.

i didnt seperate them apart, but just the display and

every ribbon cable is still in their own place

sigh.

any way to perform a self check?

the display and physical buttons are fine.

[Guest Mushroom_Lord]

Wait that's interesting. When you say the first option is always highlighted. It the screen was resistive, then it would be too much pressure on thayvpoint of the display. But we have capative screens..

[Guest Mushroom_Lord]

You may need a new digitizer, it the appear to be more expensive than the phone ATM

...

[Guest theoscat]

You may need a new digitizer, it the appear to be more expensive than the phone ATM

...

that means i have no option other than having a new one :)?

as you can see i am in hong kong :)

reallll sad