Guest KYOCERA Posted August 17, 2011 Report Posted August 17, 2011 Hey, i tried to revive my advent vega with images from clockworkmod saved on my SD, i created with vegafixer the backup, then starting flash, it stucks at sending bootloader.img , says bad data, then I tried to flash with original 1.10 img file from Adveng Vega official site and it's stuck at transfering system.img to device (Look at the picture )then i pressed CTRL+C , terminate batch job, then shutted down the device. The tried with Vega again and says (Look at the image again )
Guest Minimonkey Posted August 17, 2011 Report Posted August 17, 2011 Don't worry you can't Brick a Vega check this thread out You could just have a faulty USB cable.
Guest KYOCERA Posted August 17, 2011 Report Posted August 17, 2011 Don't worry you can't Brick a Vega check this thread out http://android.modac...-bricked-vegas/ You could just have a faulty USB cable.
Guest KYOCERA Posted August 17, 2011 Report Posted August 17, 2011 Don't worry you can't Brick a Vega check this thread out http://android.modac...-bricked-vegas/ You could just have a faulty USB cable.
Guest photons Posted August 18, 2011 Report Posted August 18, 2011 I assume you had your vega in recovery? Was your vega fully charged with power connected and powering? Download AUDI and allow the software to detect whether your vega is in recovery, one of the steps apart from putting the vega into recovery is having power supplied to your vega. Also, if possible change USB cables. And when flashing don't allow anything to interupt the process both on your pc and vega. If that doesn;t work then download a fresh copy of the 1.10 and start over, perhaps using a different pc.
Guest Unipete Posted August 18, 2011 Report Posted August 18, 2011 OP has gone AWOL it would seem :huh:
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now