Zte Blade wont turn on after charging - completely dead!

[Guest Elvenmunky]

I have tired everything, taking the battery out, using the wire from adapter, using the wire from PC...nothing works! It was fully charged before it went off. I don't know what has happened! Can anyone help?

[Guest WAWA72]

Is your USB in Blade ok? Inside. Or one offen the Contacts Brocken?

Edited September 19, 2011 by WAWA72

[Guest reluctant_traveller]

when you press and hold the power button do you see the back button illuminate red?

[Guest Elvenmunky]

The USB to computer connection is okay.

There is no lights at all showing up when i press the power button.

[Guest loff]

Have u tried the Reset button ?

[Guest Elvenmunky]

Have u tried the Reset button ?

Yes pressed it but no luck...

[Guest WAWA72]

OK, i hope you are a Pro.

1) Open the Blade

2) Open the Body

3) Now you see the Motherboard. Where the Battery come in, on the left Side up, there is a Baseband. Is it ok, is it inside the holder? On the right Side is a Cable. is it ok? Is it pressed in?

http://img6.imagebanana.com/img/3duotu08/ztebladecomponents.jpg

I opend and repaired a lot Blades. I think no ACDC does not come to the small Motherboard down from the Blade, where the Hardbuttons for Menue, Back...LEDS

Normally one of this 2 ideas, it must work. When not, you can send it me. (Germany) i do my best,

Edited September 19, 2011 by WAWA72

[Guest deepmenace]

I have tired everything, taking the battery out, using the wire from adapter, using the wire from PC...nothing works! It was fully charged before it went off. I don't know what has happened! Can anyone help?

is it an old blade?

i had a problem with a fairly old beaten up blade and it literally was just a dodgy power button. try pressing the power button a bit harder than usual - try pressing it kind of at different angles - holding down and rolling around the button a bit too - if you get even a brief flash on the red button then you'll know its just a power button problem.

[Guest t0mm13b]

OK, i hope you are a Pro.

1) Open the Blade

2) Open the Body

3) Now you see the Motherboard. Where the Battery come in, on the left Side up, there is a Baseband. Is it ok, is it inside the holder? On the right Side is a Cable. is it ok? Is it pressed in?

http://img6.imagebanana.com/img/3duotu08/ztebladecomponents.jpg

I opend and repaired a lot Blades. I think no ACDC does not come to the small Motherboard down from the Blade, where the Hardbuttons for Menue, Back...LEDS

Normally one of this 2 ideas, it must work. When not, you can send it me. (Germany) i do my best,

I recommend him to fix it for you :)

Have dealt with him and very courteous and professional manner, all-in-all, a good trustworthy guy to pull apart Blades :D

P.S: Sorry WAWA72 for the late recommendation ;)

[Guest WAWA72]

Thx tOmmi3b