Guest DMF Posted September 29, 2003 Report Posted September 29, 2003 I just followed the instructions to do a hard reset, to put the SPV back to factory specs.... I got to the canary screen and thats as far as it goes. It wont do anything by holding the action button down too or the centre pad... just says SERIAL bottom left. Any ideas ?
Guest martin Posted September 29, 2003 Report Posted September 29, 2003 How long did you leave the SPV as it usually takes longer to boot up after a hard reset. It is also advisable to do either hard resets or software upgrades with a full battery to prevent any failures during rebuild. If the hard reset still fails to recover the phone then you could try downloading the ROM software again. If you are running Orange 1.5 software then you may want to pass this to Orange CS instead.
Guest awarner [MVP] Posted September 29, 2003 Report Posted September 29, 2003 It will say serial if the phone is not connected to the PC. When promted to press any key you have to press and hold the action button, also make sure you have a storage card in as it slows down the process.
Guest DMF Posted September 29, 2003 Report Posted September 29, 2003 Top stuff thanks guys ;) - It wasnt in the pc cradle.
Guest awarner [MVP] Posted September 30, 2003 Report Posted September 30, 2003 :?: you should not need to be in the cradle to perform a Hard Rest :? Glad it's sorted anyway ;)
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now