Ceastel

[RECOVERY][ALL] TWRP 3.1.1-0 [27/05/17]

Recommended Posts

Luisk22    6

In my phone BS last approximately 2 seconds with screen timeout off or with time set for 60 or 20 seconds.

Thanks Ceastel for your great work with TWRP.

Share this post


Link to post
Share on other sites
Luisk22    6

Hi Ceastel, I´m going to test this new release of twrp, thanks for your work.

 

Edited by Luisk22

Share this post


Link to post
Share on other sites
POmniac    20

First time must wait about 2 minutes for boot to recovery.

Share this post


Link to post
Share on other sites
adeii    87

Hello, Ceastel!

Can you publish device tree(s) for this recovery?

I tried to made it from CM rom and minimal lineages tree, but none version is bootable (5.1.1, 6.0.1, 7.0.1), just blackscreen, no LEDs. My target is to made recovery that support nougat rom, somehow. 

 

Edited by adeii

Share this post


Link to post
Share on other sites
Ceastel    159

@adeii

If only this device have 1gb of ram... then port and build fully working N rom would have some sense :D
Here's u8833 device tree, for u8951 it will looks most likely the same...
However I do remember that i've had to add some patches to twrp tree itself, not sure where it was located atm x|
I was using omni 4.4 to compile that.

Good luck!

u8833-device-twrp3.zip

Edited by Ceastel

Share this post


Link to post
Share on other sites
adeii    87
On subota, 24. jun 2017. at 8:09 AM, Ceastel said:

@adeii

If only this device have 1gb of ram... then port and build fully working N rom would have some sense :D
Here's u8833 device tree, for u8951 it will looks most likely the same...
However I do remember that i've had to add some patches to twrp tree itself, not sure where it was located atm x|
I was using omni 4.4 to compile that.

Good luck!

u8833-device-twrp3.zip

Thanks for reply Ceastel, and also for the point about Nougat!
 

Share this post


Link to post
Share on other sites
Jack234    10

I am used this recovery on my G510-0200 and ADB Sideload is not working, other things are working very well

Share this post


Link to post
Share on other sites
Jack234    10

Y300 recovery builds works well on g510 without any modifications

Share this post


Link to post
Share on other sites
adeii    87
On 22.9.2017. at 3:23 AM, R87 said:

Oh nice! Thank you! I'm going to try this, does it work correctly in vee7? Can we trust the developer?

I dont know, but it is official build. Should work.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


MoDaCo is part of the MoDaCo.network, © Paul O'Brien 2002-2016. MoDaCo uses IntelliTxt technology.