Phone won't go into power saving mode after a soft reset

[Guest PCSPhone]

Help! After a soft reset, my Omnia II won't go into power saving mode if I set a password with the screen lock function. Without a password, everything is fine. It looks like the phone got stuck during the boot-up process and can't go into power saving.

I'm scheduling an automated backup during the night (which force a soft reset) and wake up with dead battery every time :) .

Is this a ROM issue and can it be fixed?

Firmware: (BELL) PDA: I8000LUGIJ6

CSC: I8000LBMCIJ6

Phone: I8000LUGIJ6

TIA

Edited November 19, 2009 by PCSPhone

[Guest touchprogeek]

I have a Bell Omnia as well. Can't say I have this problem, just something similar, when my phone is connected to my computer via USB I can't put it in standby either. My best guess is a conflict between the software I've installed and the OS on the phone. My recommendation for you and me is to do a Hard Reset and see if that fixes the problem. For you, it sounds like your only option at this point.

Backup all your important info from your phone onto your computer. Then go to Settings->Memory Settings->Clear Memory. I think this will do a Hard Reset of your phone and completely erase all settings and put the phone back to the way it was the day you bought it. Hope this helps!

[Guest PCSPhone]

I did put my phone back to factory with a hard reset but the problem is still there. You can easily reproduce it. Just go into "Settings-->Security-->Password Lock and check the "Prompt if phone unused for", put a password then click OK. Now reboot the phone and it will get stuck in power mode until the battery drains. Event if you activate power saving options.

[Guest zwq]

I did put my phone back to factory with a hard reset but the problem is still there. You can easily reproduce it. Just go into "Settings-->Security-->Password Lock and check the "Prompt if phone unused for", put a password then click OK. Now reboot the phone and it will get stuck in power mode until the battery drains. Event if you activate power saving options.

because the password lock has higher priority than the sleep mode and most of the WM functions .after you reboot the phone, the lock will lock at welcome screen and preventing the power saving mode initiate.Just enter the password ,let the phone run completely,it will not block the runing program function.

Edited November 20, 2009 by zwq

[Guest PCSPhone]

My HTC Touch running WM6.5 didn't have this problem. But then it was a customized ROM.