Guest Arr Too Posted December 23, 2010 Report Posted December 23, 2010 The start of the nand where SBL etc should be is not readable, it all dumps as FF up until the start of the normal partitions. At the risk of demonstrating to one of your parent's mother how to consume the ova of fowls :), some types of memory needs to be read in a certain way -- often this is 16-bit or 32-bit word sizes, rather than simple byte access.
Guest laspecas Posted June 9, 2011 Report Posted June 9, 2011 Hi Bricked my orange San fran during gen1 to gen2 Update. Can i use the connector you build for unbrick?
Guest t0mm13b Posted June 10, 2011 Report Posted June 10, 2011 Hi Bricked my orange San fran during gen1 to gen2 Update. Can i use the connector you build for unbrick? No, this thread is about getting output from the serial port which is mentioned here. That is not a jtag itself, its a designated RS232 port. The JTAG ports would be deeper inside the blade...
Guest mastershifu Posted June 27, 2013 Report Posted June 27, 2013 Just what i was looking for. My blade is dead thanks to corrupt bootloader, so I cant revive it via USB connection. Please advice on JTAG ports.
Guest kormen Posted January 6, 2014 Report Posted January 6, 2014 Hi! Please tell me what kernel parameter needs to work this serial? I try ir bur only the fastboot can use it.Then nothing. thx Kormen
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now