[JB][4.2.2] PAC Milestone 1 RC1 [05/08/13]

[Guest TangerineTractor]

Yes, is a know issue & yes is a OMX problem.

Sorry guys but is difficult to me because i dont have any issue with call volume-

Greetings

Not necessarily. I don't see any noticeable difference in in-call volumes on this ROM compared to any others. This is another of those wonderful Huawei discrepancies that seem to affect different devices or configurations.

[Guest Kra1o5]

Not necessarily. I don't see any noticeable difference in in-call volumes on this ROM compared to any others. This is another of those wonderful Huawei discrepancies that seem to affect different devices or configurations.

Yes, I refer to this. I dont have any problem with in call volume.

Edited May 30, 2013 by Kra1o5

[Guest cjcandrei]

The in call volume starts increasing if you are in a noisy environment. It goes to max and probably beyond in a matter of seconds. If you are in a quiet room this does not happen...

[Guest Buffalo Soldier]

Mmmm you think the volume is high or low compare with stock?

For me it's way too higher than with stock, slim, stock+...

P.S. I don't see how can this be a hardware related issue cause everything is just fine on stock-based roms.

I've talked with others on androidsrbija.com and they all have this problem, but it's not that important for all of us I guess.

Edited May 30, 2013 by Buffalo Soldier

[Guest plewis1981]

For me the phone rings twice and then the volume increases I made a log the last time I made a call in the hope it may shed some light on this problem.

PS I had noise suppression on for this call I will make a log later with it switched off.

2013-05-30-11-42-57.txt

Edited May 30, 2013 by plewis1981

[Guest Zisj]

Hi

Great ROM using ver 10 installed after a full wipe with no problems, however unable to install a different keyboard, have tried Big Button Standard and SwiftKey, both give me the error "Unfortunately, Settings has stopped" when enabling them.

Probable something that i am doing wrong but if anybody can tell me how to get around this i would be grateful.

I had this problem with MultiLing keyboard, but only when starting settings from the apllication.

I then enabled it from Settings > Languages & input and opened settings from there. That way everything worked.

Afterwards I was also able to go into settings directly from the keyboard.

[Guest bodgit]

I had this problem with MultiLing keyboard, but only when starting settings from the apllication.

I then enabled it from Settings > Languages & input and opened settings from there. That way everything worked.

Afterwards I was also able to go into settings directly from the keyboard.

Thanks for that, worked OK for me, now that i have big buttons keyboard i am finding this rom the best that i have tried.

[Guest Kra1o5]

Here a test build: http://d-h.st/F4Q

You can try now volume in call.

Greetings

[Guest y4ss1n]

i want to go back to this rom, but are the 'reboots' still present?

[Guest Mikac]

i want to go back to this rom, but are the 'reboots' still present?

Have you unlocked bootloader via official method?

[Guest Buffalo Soldier]

Here a test build: http://d-h.st/F4Q

You can try now volume in call.

Greetings

Thank you Kra1o5 for the effort, will try this in a few hours, is it ok if I just flash it over R10?

Edited May 31, 2013 by Buffalo Soldier

[Guest Kra1o5]

i want to go back to this rom, but are the 'reboots' still present?

Reboots is gone since R7.

Thank you Kra1o5 for the effort, will try this in a few hours, is it ok if I just flash it over R10?

No, problem.

[Guest Symao96]

Thank you Kra1o5 for the effort, will try this in a few hours, is it ok if I just flash it over R10?

Reboots is gone since R7.

I still have the reboots...

[Guest TangerineTractor]

Kra105 - does the new test build include your updated Kernel?

[Guest Buffalo Soldier]

Kra105 - does the new test build include your updated Kernel?

it's 3.0.8-pacman-00129-gf0a3321

[Guest TangerineTractor]

it's 3.0.8-pacman-00129-gf0a3321

So that's the standard kernel, not the experimental one?

On R10 I got lots of "not responding", especially from launcher at startup. CM10.1 seems less glitchy to me, and smoother to be honest, but I prefer some of the tweaks in this ROM, or AOKP which is a little slower. Since I finally got my bootloader unlock code, I can start testing and playing again!

Edited May 31, 2013 by TangerineTractor

[Guest Buffalo Soldier]

I've tested in-call volume with this new test build and I'm sorry to say that I don't see any difference from R10.

[Guest kyan31]

I still have the reboots...

Have you unlocked your bootloader officially?

[Guest Kra1o5]

If you still have audio issue sorry for you guys & dont have any issue with in call volume and is difficult to me repair one error i dont have.

Greetings

[Guest Buffalo Soldier]

OK Kra1o5, no problem, I was just wondering, have you tried to compare levels of audio in stock with the ones from PACMAN and CM?

[Guest Kra1o5]

I've been less than two months in stock since I have the phone :P

Greetings

[Guest Buffalo Soldier]

I've been less than two months in stock since I have the phone :P

Greetings

Sorry, I didn't understand that, but anyway, you can always flash Stock+ or Slim to see what I'm talking about, and I'm pretty sure you'll notice the difference. ;)

[Guest Kra1o5]

I dont know why in first release the volume is low & now is very high.

[Guest Symao96]

Have you unlocked your bootloader officially?

I don't think so how can I do that?

[Guest kyan31]

I don't think so how can I do that?

http://www.modaco.com/index.php?/topic/362821-[Tutorial]-How-to-[OFFICIALLY]-Unlock-The-Bootloader-[With-Definitions]-[RELOCK-Guide-Included!]

Unlocking your bootloader officially will stop reboots.